---

Hej Gruppe,

Håber i kan hjælpe mig med et spørgsmål.

Sidder og roder lidt med noget cisco udstyr,
da min viden er blevet lidt rusten.

Udstyret er:

Switch: Catalyst 2950
Router: 2600

Fik den "geniale" ide og på sigt samle mine internet
forbindelser i hver sit vlan på switchen, for derefter og
trunke disse vlan op til min router for derefter og lave et
subinterface til hver forbindelse.

Men er i mellemtiden gået i stå på at jeg ikke får en ip adresse
på det subinterface jeg bruger til test.

Nu går mit spørgsmål så på om det i det hele taget er muligt det jeg
prøver på?

Jeg vedligger lige mine to config filer fra henholdsvis router og switch.
Det drejer sig om vlan 300 på switchen og FastEthernet0/1.300 på routeren.

----------- ROUTER -----------

Current configuration : 1281 bytes
!
version 12.3
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname Router
!
boot-start-marker
boot-end-marker
!
!
no aaa new-model
!
resource policy
!
no network-clock-participate slot 1
no network-clock-participate wic 0
ip subnet-zero
ip cef
!
!
no ip dhcp use vrf connected
!
!
no ip ips deny-action ips-interface
!
no ftp-server write-enable
!
!
no crypto isakmp ccm
!
!
interface FastEthernet0/0
ip address dhcp
ip nat outside
ip virtual-reassembly
duplex auto
speed auto
!
interface FastEthernet0/1
no ip address
duplex auto
speed auto
!
interface FastEthernet0/1.100
encapsulation dot1Q 100
ip address 10.100.1.1 255.255.255.0
ip nat inside
ip virtual-reassembly
no snmp trap link-status
!
interface FastEthernet0/1.200
encapsulation dot1Q 200
ip address 10.200.1.1 255.255.255.0
no snmp trap link-status
!
interface FastEthernet0/1.300
encapsulation dot1Q 300
ip address dhcp
no snmp trap link-status
!
ip classless
!
!
ip http server
no ip http secure-server
ip nat inside source list 1 interface FastEthernet0/0 overload
!
access-list 1 permit 10.0.0.0 0.255.255.255
!
control-plane
!
!
line con 0
line aux 0
line vty 0 4
end

----------- SWITCH -----------

Current configuration : 2300 bytes
!
version 12.1
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname Switch
!
!
ip subnet-zero
!
!
spanning-tree mode pvst
no spanning-tree optimize bpdu transmission
spanning-tree extend system-id
!
!
!
!
interface FastEthernet0/1
switchport access vlan 100
switchport mode access
!
interface FastEthernet0/2
switchport access vlan 100
switchport mode access
!
interface FastEthernet0/3
switchport access vlan 100
switchport mode access
!
interface FastEthernet0/4
switchport access vlan 100
switchport mode access
!
interface FastEthernet0/5
switchport access vlan 100
switchport mode access
!
interface FastEthernet0/6
switchport access vlan 100
switchport mode access
!
interface FastEthernet0/7
switchport access vlan 100
switchport mode access
!
interface FastEthernet0/8
switchport access vlan 100
switchport mode access
!
interface FastEthernet0/9
switchport access vlan 100
switchport mode access
!
interface FastEthernet0/10
switchport access vlan 100
switchport mode access
!
interface FastEthernet0/11
switchport access vlan 200
switchport mode access
!
interface FastEthernet0/12
switchport access vlan 200
switchport mode access
!
interface FastEthernet0/13
switchport access vlan 200
switchport mode access
!
interface FastEthernet0/14
switchport access vlan 200
switchport mode access
!
interface FastEthernet0/15
switchport access vlan 200
switchport mode access
!
interface FastEthernet0/16
switchport access vlan 200
switchport mode access
!
interface FastEthernet0/17
switchport access vlan 200
switchport mode access
!
interface FastEthernet0/18
switchport access vlan 200
switchport mode access
!
interface FastEthernet0/19
switchport access vlan 200
switchport mode access
!
interface FastEthernet0/20
switchport access vlan 200
switchport mode access
!
interface FastEthernet0/21
!
interface FastEthernet0/22
!
interface FastEthernet0/23
switchport access vlan 300
switchport mode access
!
interface FastEthernet0/24
switchport mode trunk
!
interface GigabitEthernet0/1
!
interface GigabitEthernet0/2
!
interface Vlan1
no ip address
no ip route-cache
shutdown
!
ip http server
!
line con 0
line vty 5 15
!
!
end
--
Venlig Hilsen
Kristian

---

---

Michael Rasmussen wrote:

Det hjælper jo ikke noget du sender vedhæftet
fil, den bliver bortfiltreret på TDC server

---

SÃ¥ vidt jeg kan se mangler du kun DHCP serveren, den servere skal
selvf. kunne se alle VLANS og der skal være scopes til hvert IP
segment. Husk din def. gw. skal være vlan IP.

mvh
Kenneth


Kristian W. Asmussen skrev:
> Hej Gruppe,
>
> H�ber i kan hj�lpe mig med et sp�rgsm�l.
>
> Sidder og roder lidt med noget cisco udstyr,
> da min viden er blevet lidt rusten.
>
> Udstyret er:
>
> Switch: Catalyst 2950
> Router: 2600
>
> Fik den "geniale" ide og p� sigt samle mine internet
> forbindelser i hver sit vlan p� switchen, for derefter og
> trunke disse vlan op til min router for derefter og lave et
> subinterface til hver forbindelse.
>
> Men er i mellemtiden g�et i st� p� at jeg ikke f�r en ip adresse
> p� det subinterface jeg bruger til test.
>
> Nu g�r mit sp�rgsm�l s� p� om det i det hele taget er muligt det jeg
> pr�ver p�?
>
> Jeg vedligger lige mine to config filer fra henholdsvis router og switch.
> Det drejer sig om vlan 300 p� switchen og FastEthernet0/1.300 p� routeren.
>
> ----------- ROUTER -----------
>
> Current configuration : 1281 bytes
> !
> version 12.3
> service timestamps debug datetime msec
> service timestamps log datetime msec
> no service password-encryption
> !
> hostname Router
> !
> boot-start-marker
> boot-end-marker
> !
> !
> no aaa new-model
> !
> resource policy
> !
> no network-clock-participate slot 1
> no network-clock-participate wic 0
> ip subnet-zero
> ip cef
> !
> !
> no ip dhcp use vrf connected
> !
> !
> no ip ips deny-action ips-interface
> !
> no ftp-server write-enable
> !
> !
> no crypto isakmp ccm
> !
> !
> interface FastEthernet0/0
> ip address dhcp
> ip nat outside
> ip virtual-reassembly
> duplex auto
> speed auto
> !
> interface FastEthernet0/1
> no ip address
> duplex auto
> speed auto
> !
> interface FastEthernet0/1.100
> encapsulation dot1Q 100
> ip address 10.100.1.1 255.255.255.0
> ip nat inside
> ip virtual-reassembly
> no snmp trap link-status
> !
> interface FastEthernet0/1.200
> encapsulation dot1Q 200
> ip address 10.200.1.1 255.255.255.0
> no snmp trap link-status
> !
> interface FastEthernet0/1.300
> encapsulation dot1Q 300
> ip address dhcp
> no snmp trap link-status
> !
> ip classless
> !
> !
> ip http server
> no ip http secure-server
> ip nat inside source list 1 interface FastEthernet0/0 overload
> !
> access-list 1 permit 10.0.0.0 0.255.255.255
> !
> control-plane
> !
> !
> line con 0
> line aux 0
> line vty 0 4
> end
>
> ----------- SWITCH -----------
>
> Current configuration : 2300 bytes
> !
> version 12.1
> no service pad
> service timestamps debug uptime
> service timestamps log uptime
> no service password-encryption
> !
> hostname Switch
> !
> !
> ip subnet-zero
> !
> !
> spanning-tree mode pvst
> no spanning-tree optimize bpdu transmission
> spanning-tree extend system-id
> !
> !
> !
> !
> interface FastEthernet0/1
> switchport access vlan 100
> switchport mode access
> !
> interface FastEthernet0/2
> switchport access vlan 100
> switchport mode access
> !
> interface FastEthernet0/3
> switchport access vlan 100
> switchport mode access
> !
> interface FastEthernet0/4
> switchport access vlan 100
> switchport mode access
> !
> interface FastEthernet0/5
> switchport access vlan 100
> switchport mode access
> !
> interface FastEthernet0/6
> switchport access vlan 100
> switchport mode access
> !
> interface FastEthernet0/7
> switchport access vlan 100
> switchport mode access
> !
> interface FastEthernet0/8
> switchport access vlan 100
> switchport mode access
> !
> interface FastEthernet0/9
> switchport access vlan 100
> switchport mode access
> !
> interface FastEthernet0/10
> switchport access vlan 100
> switchport mode access
> !
> interface FastEthernet0/11
> switchport access vlan 200
> switchport mode access
> !
> interface FastEthernet0/12
> switchport access vlan 200
> switchport mode access
> !
> interface FastEthernet0/13
> switchport access vlan 200
> switchport mode access
> !
> interface FastEthernet0/14
> switchport access vlan 200
> switchport mode access
> !
> interface FastEthernet0/15
> switchport access vlan 200
> switchport mode access
> !
> interface FastEthernet0/16
> switchport access vlan 200
> switchport mode access
> !
> interface FastEthernet0/17
> switchport access vlan 200
> switchport mode access
> !
> interface FastEthernet0/18
> switchport access vlan 200
> switchport mode access
> !
> interface FastEthernet0/19
> switchport access vlan 200
> switchport mode access
> !
> interface FastEthernet0/20
> switchport access vlan 200
> switchport mode access
> !
> interface FastEthernet0/21
> !
> interface FastEthernet0/22
> !
> interface FastEthernet0/23
> switchport access vlan 300
> switchport mode access
> !
> interface FastEthernet0/24
> switchport mode trunk
> !
> interface GigabitEthernet0/1
> !
> interface GigabitEthernet0/2
> !
> interface Vlan1
> no ip address
> no ip route-cache
> shutdown
> !
> ip http server
> !
> line con 0
> line vty 5 15
> !
> !
> end
> --
> Venlig Hilsen
> Kristian