On Sat, 28 Jul 2007 21:24:02 +0200, "Hans" <nospam@kvik.org.invalid>
wrote:
>Rado wrote:
>> Hvis man laver et image af en XP installation på et PATA drev og så
>> flytter det over på en SATA disk (samme maskine, samme
>> partition/drevbogstav), vil der så være problemer med drivere når man
>> booter op på SATA drevet?
>>
>> I så fald, hvordan løser man det problem?
>>
>Installerer SATA driverne inden installationen flyttes, hvis SATA disken
>ikke understøttes direkte i bundkortets sydbro.
Tillader Windows det?
Og hvad betyder det at SATA diske understøttes af sydbroen? Har det
noget at gøre med hvilken type SATA disk der er tale om (150/300)?
>Hvilket bundkort handler det om?
Intel DG33FB:
http://www.intel.com/products/motherboard/dg33fb/
Der står desværre ikke meget om SATA i manualen:
1.6.4.1 Serial ATA Support The DG33FB Desktop Board’s Serial ATA
controller offers four independent Serial ATA ports with a theoretical
maximum transfer rate of 3 Gbits/sec per port. One device can be
installed on each port for a maximum of four Serial ATA devices. A
point-to-point interface is used for host to device connections,
unlike Parallel ATA IDE which supports a master/slave configuration
and two devices per channel.
For compatibility, the underlying Serial ATA functionality is
transparent to the operating system. The Serial ATA controller can
operate in both legacy and native modes. In legacy mode, standard IDE
I/O and IRQ resources are assigned (IRQ 14 and 15). In Native mode,
standard PCI Conventional bus resource steering is used. Native mode
is the preferred mode for configurations using the Windows* XP
operating system.
--
Rado
Intelligence is that faculty of mind, by which order is perceived in a situation
previously considered disordered.- Haneef A. Fatmi